DrySystem

There are four parts in the DrySystem package:

•Dryvent

•ZincoRete 2,5

•Expansion fixings

•Soffio

DrySystem is ideal both for new building projects and for renovations.
Particularly suitable for facings laid with glue, such as natural or manufactured stone, terracotta brick-slips, clinker, ceramic, block stone walls, facing bricks and plaster. It can be applied to all kinds of supports, brickwork, cement blocks, reinforced concrete, wood, etc.

Perfect for the covering of reinforced concrete walls contiguous to earth where it is likely or you suppose that humidity or water from the ground could reach the wall. DrySystem creates a protection for the facing by avoiding problems, such as the formations of mould, surfacing saline bloomings or the detachment of products.

In facing houses’ external walls, where it’s necessary to foresee their tranpiration, DrySystem allows the outgoing of the condensation that forms inside the house. DrySystem can be used to repair old walls where humidity has made the plaster crumble or where the facing has deteriorated.

1. Dryvent: made from 10 mm undulated recycled plastic, with narrow slits for horizontal and vertical ventilation. Pre-coupled with a transparent but water-repellant polyester membrane. Light and easy to bend for all kinds of support.
2. Water-repellant polyester membrane.
3. ZincoRete 2,5:  a support grid for all kinds of facing and plaster. It is made of galvanized iron and comes in 1000 x 2000 mm flat sheets.
4. Expansion fixings: they are the anchor and the support of the entire wall.
5. B&B glue: rough coat that covers the grid before the facing is glued on.
6. Soffio: “L” shaped wall bracket that is also made from undulated recycled plastic like Dryvent. It is placed behind Dryvent to improve air circulation and to allow humidity and residual water to drain out.